Toyota Highlander Service Manual: Emission control
Toyota Highlander Service Manual / Emission control
- Emission control system (2AZ-FE)
- Charcoal canister ASSY (2AZ-FE)
- Emission control system (3MZ-FE)
- Charcoal canister ASSY (3MZ-FE)
- Ventilation valve Sub-ASSY (3MZ-FE)
- Intake air control system (3MZ-FE)
- Intake air control valve ASSY NO.2 (3MZ-FE)
- Engine (2AZ-FE)
- Fan and generator v belt (2AZ-FE)
- Valve clearance (2AZ-FE)
- Partial engine ASSY (2AZ-FE)
- Chain (2AZ-FE)
- Camshaft (2AZ-FE)
- Cylinder head gasket (2AZ-FE)
- Timing gear case or timing chain case oil seal (2AZ-FE)
- Engine rear oil seal (2AZ-FE)
- Cylinder head ASSY (2AZ-FE)
- Cylinder block ASSY (2AZ-FE)
- Engine (3MZ-FE)
- Drive belt (3MZ-FE)
- Valve clearance (3MZ-FE)
- Partial engine ASSY (3MZ-FE)
- Timing belt (3MZ-FE)
- Camshaft (RH BANK) (3MZ-FE)
- Camshaft (LH BANK) (3MZ-FE)
- Cylinder head gasket (3MZ-FE)
- Cylinder head gasket NO.2 (3MZ-FE)
- Oil pump seal (3MZ-FE)
- Engine rear oil seal (3MZ-FE)
- Cylinder head ASSY (3MZ-FE)
- Cylinder block ASSY (3MZ-FE)
Replacement
1. DISCHARGE FUEL SYSTEM PRESSURE (See page 11-35 )
2. REMOVE DECK BOARD SUB-ASSY
3. REMOVE REAR SEAT TRACK BRACKET COVER OUTER
4. REMOVE REAR SEAT ASSY RH (See page 72-35 )
5. REMOVE REAR SEAT AS ...
More about Toyota Highlander:
Roof drip side finish moulding center LH
REPLACEMENT
HINT:
The installation is in the reverse order of the removal. However,
when there is a special point concerning
the installation, it is indicated.
On the RH side, use the same procedures as on the LH side.
1. REMOVE ROOF DRIP SIDE FINISH MOULDING CENTER LH
(a) Cover ...
В© 2011-2025 Copyright www.tohighlander.com
