Toyota Highlander Service Manual: Front differential oil seal (U151F)
REPLACEMENT
HINT: When replacing the front differential oil seal (LH) or (RH), perform step 1 to 11 or 12 to 23 respectively.
1. REMOVE FRONT WHEEL
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and the drain plug.
Torque: 49 NVm (500 kgfVcm, 36 ftVlbf)
4. REMOVE FRONT DRIVE SHAFT ASSY LH (SEE PAGE 30-21 )
SST 09520-01010, 09520-24010 (09520-32040)
5. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL
(a) Using SST, pull out the oil seal.
SST 09308-00010
6. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL
(a) Using SST and a hammer, drive in a new oil seal.
SST 09223-15020, 09950-70010 (09951-07200)
Oil seal drive in depth: 0 0.5 mm (0 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
7. INSTALL FRONT DRIVE SHAFT ASSY LH (SEE PAGE 30-21 )
8. INSTALL FRONT WHEEL
9. ADD AUTOMATIC TRANSAXLE FLUID
10. INSPECT AUTOMATIC TRANSAXLE FLUID (SEE PAGE 40-2 )
11. INSTALL ENGINE UNDER COVER NO.1
12. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (SEE PAGE 14-149 )
13. REMOVE FRONT DRIVE SHAFT ASSY RH (SEE PAGE 30-21 )
SST 09520-01010, 09520-24010 (09520-32040)
14. REMOVE TRANSFER STIFFENER PLATE RH (SEE PAGE 40-20 )
15. REMOVE AUTOMATIC TRANSMISSION W/TRANSFER (SEE PAGE 40-20 )
16. REMOVE TRANSFER ASSY (SEE PAGE 31-9 )
17. REMOVE TRANSAXLE HOUSING OIL SEAL
(a) Using a screwdriver with vinyl tape wrapped around its tip, remove the oil seal.
NOTICE: Be careful not to damage the housing.
18. INSTALL TRANSAXLE HOUSING OIL SEAL
(a) Using SST and a hammer, drive in a new oil seal.
SST 09649-17010, 09950-70010 (09951-07200)
Oil seal drive in depth: 6.0 0.5 mm (0.236 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
19. INSTALL TRANSFER ASSY (SEE PAGE 31-9 )
20. INSTALL AUTOMATIC TRANSMISSION W/TRANSFER (SEE PAGE 40-20 )
21. INSTALL TRANSFER STIFFENER PLATE RH (SEE PAGE 40-20 )
22. INSTALL FRONT DRIVE SHAFT ASSY RH (SEE PAGE 30-21 )
23. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE (SEE PAGE 14-149 )
24. RESET MEMORY (SEE PAGE 05-1005 )
25. PERFORM INITIALIZATION (SEE PAGE 01-4 )
Front differential oil seal (U151E)
REPLACEMENT
1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and the drain plu ...
Shift lock system (ATM)
ON-VEHICLE INSPECTION
1. CHECK SHIFT LOCK OPERATION
(a) Shift the shift lever to P position.
(b) Turn the ignition switch to LOCK.
(c) Check that the shift lever cannot be shifted to any other pos ...
More about Toyota Highlander:
Pre-check
1. SELECT COMPASS DISPLAY MODE
(a) The COMP switch allows you to select the "Display" or "Non-display" mode
of the compass.
2. SET ZONE
(a) The location of magnetic north and true north differs depending on the
location. Adjustment of the compass's
magnetism is required to correct possible c ...
