Toyota Highlander Service Manual: Front differential oil seal (U151E)
REPLACEMENT
1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and the drain plug.
Torque: 49 NVm (500 kgfVcm, 36 ftVlbf)
4. REMOVE FRONT DRIVE SHAFT ASSY LH (SEE PAGE 30-21 )
SST 09520-01010, 09520-24010 (09520-32040)
5. REMOVE FRONT DRIVE SHAFT ASSY RH (2WD DRIVE TYPE) (SEE PAGE 30-21 )
6. REMOVE TRANSAXLE HOUSING OIL SEAL
(a) Using SST, pull out the oil seal.
SST 09308-00010
7. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL
(a) Using SST, pull out the oil seal.
SST 09308-00010
8. INSTALL TRANSAXLE HOUSING OIL SEAL
(a) Using SST and a hammer, drive in a new oil seal.
SST 09316-6001 1 (09316-00011)
Oil seal drive in depth: 0 0.5 mm (0 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
9. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL
(a) Using SST and a hammer, drive in a new oil seal.
SST 09223-15020, 09950-70010 (09951-07150)
Oil seal drive in depth: 0 0.5 mm (0 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
10. INSTALL FRONT DRIVE SHAFT ASSY LH (SEE PAGE 30-21 )
11. INSTALL FRONT DRIVE SHAFT ASSY RH (2WD DRIVE TYPE) (SEE PAGE 30-21 )
12. INSTALL FRONT WHEELS
Torque: 103 NVm (1,050 kgfVcm, 76 ftVlbf)
13. ADD AUTOMATIC TRANSAXLE FLUID
14. INSPECT AUTOMATIC TRANSAXLE FLUID (SEE PAGE 40-2 )
15. INSTALL ENGINE UNDER COVER NO.1
16. CHECK ABS SPEED SENSOR SIGNAL (SEE PAGE 05-765 )
Front differential oil seal (U140F)
REPLACEMENT
HINT:
When replacing the front differential oil seal (LH) or (RH), perform step 1 to
11 or 12 to 21 respectively.
1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN A ...
Front differential oil seal (U151F)
REPLACEMENT
HINT:
When replacing the front differential oil seal (LH) or (RH), perform step 1 to
11 or 12 to 23 respectively.
1. REMOVE FRONT WHEEL
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN AU ...
More about Toyota Highlander:
On-vehicle inspection
1. CHECK AUTO OPERATION
HINT:
When pressing the switch for 0.3 seconds or less, the roof glass moves but auto
operation does not operate.
(a) Turn the ignition switch ON.
(b) When the roof glass is fully closed, check that pressing the slide roof open
side of the sliding roof switch
for 0.3 ...
