Toyota Highlander Service Manual: Windshield wiper switch ASSY
REPLACEMENT
HINT: Installation is in the reverse order of removal.
1. REMOVE STEERING COLUMN COVER LWR (SEE PAGE 50-8 )
2. REMOVE STEERING COLUMN COVER UPR (SEE PAGE 50-8 )
3. REMOVE WINDSHIELD WIPER SWITCH ASSY
(a) Disconnect the connector.
(b) Using a screwdriver, disengage the claw, and remove the windshield wiper switch assy.
NOTICE: Pressing the claw hard breaks the claw.
HINT: Tape the screwdriver tip before use.
Rear wiper rubber
REPLACEMENT
HINT:
Installation is in the reverse order of removal.
1. REMOVE REAR WIPER BLADE ASSY
(a) Raise the rear wiper blade assy to the position where the
claw disengages with a click s ...
Washer nozzle
INSPECTION
1. INSPECT WASHER NOZZLE
(a) With the engine running, check that the washer fluid hits in the range
indicated by the hatched areas
on the windshield and the rear window.
HINT:
This w ...
More about Toyota Highlander:
How to proceed with troubleshooting
HINT:
Carry out troubleshooting in accordance with the procedures below. Only a basic
procedure is shown. Details
in the Diagnostic Section show the most effective methods for each circuit.
Confirm the troubleshooting
procedures for the relevant circuit before beginning troubleshooting.
1 VE ...
