Toyota Highlander Service Manual: Oil W/hose cooler ASSY (U151E/U151F)
REPLACEMENT
1. REMOVE FRONT BUMPER COVER (SEE PAGE 76-2 )
2. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug and gasket, and drain ATF.
(b) Install a new gasket and the drain plug.
Torque: 49 NVm (500 kgfVcm, 36 ftVlbf)
3. REMOVE OIL COOLER ASSY
(a) Disconnect the 2 oil cooler hoses.
(b) Remove the bolt, nut and oil cooler assy.
4. INSTALL OIL COOLER ASSY
(a) Install the oil cooler assy, bolt A and nut B.
HINT: After temporarily tightening the bolt A, fully tighten in order of the nut B, bolt A.
Torque: 7.0 NVm (71 kgfVcm, 62 in.Vlbf)
(b) Connect the 2 oil cooler hoses.
5. INSTALL FRONT BUMPER COVER (SEE PAGE 76-2 )
6. ADD AUTOMATIC TRANSAXLE FLUID
7. INSPECT AUTOMATIC TRANSAXLE FLUID (SEE PAGE 40-2 )
Oil W/hose cooler ASSY (U241E/U140F)
REPLACEMENT
1. REMOVE RADIATOR GRILLE (See page 76-2 )
2. REMOVE FRONT BUMPER COVER (See page 76-2 )
3. SEPARATE OIL COOLER OUTLET TUBE NO.1
(a) Loosen the clip and separate the oil cooler hose.
...
Front differential oil seal (U241E)
REPLACEMENT
1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and drain plug.
...
More about Toyota Highlander:
Network gateway ECU
REPLACEMENT
HINT:
COMPONENTS: See page 67-2
Installation is in the reverse order of removal.
1. REMOVE GLOVE COMPARTMENT DOOR ASSY (SEE PAGE 71-10 )
2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO.2 (SEE PAGE 71-10 )
3. REMOVE NETWORK GATEWAY ECU
(a) Disconnect the connector.
(b) ...
