Toyota Highlander Service Manual: Rear door belt moulding ASSY LH
Toyota Highlander Service Manual / Exterior/interior trim / Rear door belt moulding ASSY LH
REPLACEMENT
HINT:
- The installation procedures are the removal procedures in reverse order.
- Use the same procedures for the RH side and LH side.
1. REMOVE DOOR PULL HANDLE (See page 75-13 )
2. REMOVE REAR DOOR TRIM BOARD SUB-ASSY LH (See page 75-13 )
3. REMOVE REAR DOOR BELT MOULDING ASSY LH
(a) Remove the screw.
(b) Put protective tape under the moulding.
(c) Using a moulding remover or scraper, remove the moulding.
Front door belt moulding ASSY LH
REPLACEMENT
HINT:
The installation procedures are the removal procedures in reverse
order.
Use the same procedures for the RH side and LH side.
1. REMOVE POWER WINDOW REGULATOR SWITCH ASS ...
Luggage compartment door garnish sub-ASSY
outside
REPLACEMENT
1. REMOVE BACK WINDOW PANEL TRIM UPPER (See page 75-20 )
2. REMOVE BACK DOOR TRIM COVER RH (See page 75-20 )
3. REMOVE BACK DOOR TRIM COVER LH (See page 75-20 )
4. REMOVE BACK DOOR TRI ...
More about Toyota Highlander:
Thermostat (3MZ-FE)
REPLACEMENT
HINT:
The installation procedures are the removal procedures in reverse order.
However, only installation procedures
requiring additional information are included.
1. DRAIN ENGINE COOLANT (See page 16-26 )
2. REMOVE RADIATOR HOSE OUTLET
3. REMOVE WATER INLET PIPE
(a) Remove the ...
В© 2011-2026 Copyright www.tohighlander.com
