Toyota Highlander Service Manual: Front door belt moulding ASSY LH
Toyota Highlander Service Manual / Exterior/interior trim / Front door belt moulding ASSY LH
REPLACEMENT
HINT:
- The installation procedures are the removal procedures in reverse order.
- Use the same procedures for the RH side and LH side.
1. REMOVE POWER WINDOW REGULATOR SWITCH ASSY (See page 75-6 )
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH (See page 75-6 )
3. REMOVE DOOR PULL HANDLE (See page 75-6 )
4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSY LH (See page 75-6 )
5. REMOVE FRONT DOOR BELT MOULDING ASSY LH
(a) Remove the screw.
(b) Put protective tape under the moulding.
(c) Using a moulding remover or scraper, remove the moulding.
Rear spoiler
REPLACEMENT
1. REMOVE BACK WINDOW PANEL TRIM UPPER (See page 75-20 )
2. REMOVE REAR SPOILER
(a) Remove the 2 bolts and nut.
(b) Using a heat light, heat the body and rear spoiler to 40 to
60 ...
Rear door belt moulding ASSY LH
REPLACEMENT
HINT:
The installation procedures are the removal procedures in reverse
order.
Use the same procedures for the RH side and LH side.
1. REMOVE DOOR PULL HANDLE (See page 75-13 ...
More about Toyota Highlander:
Engine rear oil seal (2AZ-FE)
REPLACEMENT
1. REMOVE AUTOMATIC TRANSAXLE ASSY (See page 40-12 )
HINT:
Remove and install the transaxle after removing the engine assy w/ transaxle.
2. REMOVE DRIVE PLATE & RING GEAR SUB-ASSY
(a) Using SST, fix the crankshaft.
SST 09213-54015 (91651-60855), 09330-00021
(b) Remov ...
В© 2011-2026 Copyright www.tohighlander.com
