Toyota Highlander Service Manual: Luggage compartment door garnish sub-ASSY outside
REPLACEMENT
1. REMOVE BACK WINDOW PANEL TRIM UPPER (See page 75-20 )
2. REMOVE BACK DOOR TRIM COVER RH (See page 75-20 )
3. REMOVE BACK DOOR TRIM COVER LH (See page 75-20 )
4. REMOVE BACK DOOR TRIM PANEL ASSY (See page 75-20 )
5. REMOVE REAR SPOILER (W/ REAR SPOILER) (See page 75-20 )
6. REMOVE BACK DOOR LOCK ASSY (See page 75-20 )
7. REMOVE BACK DOOR HANDLE ASSY OUTSIDE (See page 75-20 )
8. REMOVE LUGGAGE COMPARTMENT DOOR GARNISH SUB-ASSY OUTSIDE
(a) Remove the screws and the 2 licence plate lights.
(b) Remove the nut and garnish.
9. INSTALL LUGGAGE COMPARTMENT DOOR NAME PLATE NO.1
(a) Using white gasoline, clean the garnish installation surface.
(b) Using a heat light, heat the garnish and name plate to 20 to 30 C (68 to 86 F).
(c) Install the name plate.
NOTICE: Do not heat the garnish and name plate excessively.
Rear door belt moulding ASSY LH
REPLACEMENT
HINT:
The installation procedures are the removal procedures in reverse
order.
Use the same procedures for the RH side and LH side.
1. REMOVE DOOR PULL HANDLE (See page 75-13 ...
Outside moulding
REPLACEMENT
HINT:
The installation procedures are the removal procedures in reverse
order. However, only installation
procedures requiring additional information are included.
Use the same ...
More about Toyota Highlander:
Skid control sensor (FF)
REPLACEMENT
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. REMOVE REAR WHEEL
2. DISCONNECT SKID CONTROL SENSOR WIRE
(a) Disconnect the connector from the skid control sensor.
3. SEPARATE REAR DISC BRAKE CALIPER ASSY LH (SEE ...
