Toyota Highlander Service Manual: License plate lamp ASSY
REPLACEMENT
HINT: Installation is in the reverse order of removal.
1. REMOVE ASSIST STRAP HOLE COVER (SEE PAGE 75-20 )
2. REMOVE ASSIST STRAP ASSY RH (SEE PAGE 75-20 )
3. REMOVE BACK DOOR TRIM PANEL ASSY (SEE PAGE 75-20 )
4. REMOVE BACK DOOR LOCK ASSY (SEE PAGE 75-20 )
5. REMOVE BACK DOOR HANDLE ASSY OUTSIDE (SEE PAGE 75-20 )
6. REMOVE LUGGAGE COMPARTMENT DOOR GARNISH SUB-ASSY OUTSIDE (SEE PAGE 76-13 )
7. REMOVE LICENSE PLATE LAMP ASSY
(a) Remove the 4 screws and the 2 license plate lamp lenses.
(b) Remove the license plate lamp assy from the luggage compartment door garnish sub-assy outside.
8. INSTALL BACK DOOR LOCK ASSY (SEE PAGE 75-20 )
Rear combination lamp ASSY LH
OVERHAUL
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
Installation is in the reverse order of removal.
1. REMOVE REAR COMBINA ...
Center stop lamp ASSY
REPLACEMENT
HINT:
Installation is in the reverse order of removal.
1. REMOVE BACK WINDOW PANEL TRIM UPPER (SEE PAGE 75-20 )
2. REMOVE CENTER STOP LAMP SOCKET & WIRE
(a) Disconnect the connect ...
More about Toyota Highlander:
Drive belt (3MZ-FE)
REPLACEMENT
1. REMOVE FRONT WHEEL RH
2. REMOVE ENGINE UNDER COVER NO.1
3. REMOVE FRONT FENDER APRON SEAL RH
4. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Loosen bolts A and B.
(b) Loosen adjusting bolt C and remove the belt.
5. REMOVE VANE PUMP V BELT
(a) Loosen ...
