Toyota Highlander Service Manual: Front axle LH hub bolt
REPLACEMENT
HINT: COMPONENTS:SEE PAGE 30-4 Replace the RH side by the same procedures with LH side.
1. REMOVE FRONT WHEEL
2. SEPARATE FRONT DISC BRAKE CALIPER ASSY LH(SEE PAGE 30-38 )
3. REMOVE FRONT DISC
4. REMOVE FRONT AXLE LH HUB BOLT
(a) Using SST and a screwdriver or an equivalent to hold, remove the hub bolt.
SST 09628-1001 1
5. INSTALL FRONT AXLE LH HUB BOLT
(a) Install a washer and nut to a new hub bolt as shown in the illustration.
(b) Using a screwdriver to hold, install the hub bolt by torquing the nut.
6. INSTALL FRONT DISC
7. INSTALL FRONT DISC BRAKE CALIPER ASSY LH (SEE PAGE 30-38 )
8. INSTALL FRONT WHEEL
Torque: 103 NVm (1,050 kgfVcm, 76 ftVlbf)
Front axle hub sub-ASSY LH
REPLACEMENT
HINT:
COMPONENTS: SEE PAGE 30-4
Replace the RH side by the same procedures with LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT AXLE HUB LH NUT
(a) Using SST and a hammer, unstake ...
Rear drive shaft (4WD)
OVERHAUL
HINT:
COMPONENTS: SEE PAGE 30-4
Overhaul the RH side using the same procedures as for the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE SPEED SENSOR REAR LH
(a) Remove the bolt and the spee ...
More about Toyota Highlander:
On-vehicle inspection
1. INSPECT TURN SIGNAL FLASHER CIRCUIT
(a) Disconnect the connector from the turn signal flasher
relay.
(b) Measure the voltage according to the value(s) in the table
below.
Standard
(c) Reconnect the connector to the turn signal flasher.
(d) Measure the voltage according to the valve ...
