Toyota Highlander Service Manual: Drive belt (3MZ-FE)
REPLACEMENT
1. REMOVE FRONT WHEEL RH
2. REMOVE ENGINE UNDER COVER NO.1
3. REMOVE FRONT FENDER APRON SEAL RH
4. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Loosen bolts A and B.
(b) Loosen adjusting bolt C and remove the belt.
5. REMOVE VANE PUMP V BELT
(a) Loosen bolts A and B, and remove the belt.
6. INSTALL VANE PUMP V BELT
(a) Install the belt on each pulley.
(b) Using a bar, adjust the belt tension and tighten bolt B.
Torque: 43 NVm (438 kgfVcm, 32 ftVlbf) (c) Tighten bolt A.
Torque: 43 NVm (438 kgfVcm, 32 ftVlbf)
7. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Install the belt on each pulley.
(b) Tighten adjusting bolt C, and adjust the belt tension.
(c) First tighten bolt A, and then B.
Torque: 58 NVm (591 kgfVcm, 43 ftVlbf) for bolt A 18 NVm (184 kgfVcm, 13 ftVlbf) for bolt B
8. INSPECT DRIVE BELT TENSION (See page 14-121 )
9. INSTALL FRONT WHEEL RH
Engine (3MZ-FE)
INSPECTION
1. INSPECT ENGINE COOLANT (See page 16-20 )
2. INSPECT ENGINE OIL
3. INSPECT BATTERY (See page 19-36 )
4. INSPECT AIR CLEANER FILTER ELEMENT SUB-ASSY
5. INSPECT SPARK PLUG (See page 18 ...
Valve clearance (3MZ-FE)
ADJUSTMENT
1. DRAIN ENGINE COOLANT (See page 16-26 )
2. REMOVE FR WIPER ARM LH (See page 66-7 )
3. REMOVE FR WIPER ARM RH (See page 66-7 )
4. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSY (See page 6 ...
More about Toyota Highlander:
Engine oil
With the engine at operating temperature and turned off, check the oil
level on the dipstick.
Checking the engine oil
Park the vehicle on level ground. After warming up the engine
and turning it off, wait more than 5 minutes for the oil to drain
back into the bottom of the engine.
Holdin ...
