REPLACEMENT
HINT:
1. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSY (SEE PAGE 75-6 )
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH (SEE PAGE 75-6 )
3. REMOVE DOOR PULL HANDLE (SEE PAGE 75-6 )
4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSY LH (SEE PAGE 75-6 )
5. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSY LH (SEE PAGE 75-6 )
6. REMOVE FRONT NO.1 SPEAKER ASSY

(a) Disconnect the connector.
(b) Remove the 3 screws and front No. 1 speaker assy.
7. INSTALL FRONT NO.1 SPEAKER ASSY

(a) Install the front No.1 speaker assy with the 3 screws.
(b) Connect the connector.
Navigation ECU
Front NO.2 speaker ASSYOn-vehicle inspection
1. CONNECT HAND-HELD TESTER:
(a) Connect the hand-held tester to the DLC3.
(b) Start the engine and run at idle.
(c) Select the ACTIVE TEST mode on the hand-held tester.
HINT: Please refer to the hand-held tester operator's manual for
further
details.
2. INSPECT ACTUATOR MOTOR OPERATION
...