Toyota Highlander Service Manual: Adjustment

Toyota Highlander Service Manual / Heater & air conditioner / V (cooler compressor to crankshaft pulley) belt NO.1 / Adjustment

1. ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

(a) Loosen bolt A.

(b) Loosen bolt B.

Drive belt tension: New belt: 160 to 180 lbf Used belt: 115 to 135 lbf

ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

HINT:

"New V belt" refers to a belt which has been used for less than 5 minutes on a running engine.
"Used V belt" refers to a belt which has been used for 5 minutes or more on a running engine

ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

(d) Tighten bolt A.

Torque: 58 NVm (591 kgfVcm, 43 ftVlbf) (e) Tighten bolt B.

Torque: 18 NVm (183 kgfVcm, 13 ftVlbf)

Replacement

1. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1 (a) Loosen bolt A. (b) Loosen bolt B. (c) Loosen bolt C and remove the V belt. 2. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULL ...

Integration control & panel ASSY

COMPONENTS OVERHAUL HINT: COMPONENTS: see page 55-25 1. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSY CENTER (SEE PAGE 71-10 ) 2. REMOVE INTEGRATION CONTROL & PANEL ASSY (SEE PAGE 71-10 ...

More about Toyota Highlander:

Rear suspension arm ASSY NO.2 LH (4WD)
REPLACEMENT HINT: COMPONENTS: See page 27-2 . 1. REMOVE REAR WHEEL 2. REMOVE REAR SUSPENSION ARM ASSY NO.2 LH (a) Support the rear axle carrier with a jack. (b) Place matchmarks on the adjust cams and rear suspension member sub-assy. (c) Remove the nut, camber adjust cam and toe adjust c ...