Operating the wiper lever
The wiper operation is selected by moving the lever as follows:
*1 Or
*2 Intermittent window
*1 Or
*2 Normal window wiper

*1: For u.S.A.
*2: For canada
The wiper will automatically operate a couple of times after the washer squirts.

The rear window wiper and washer can be operated when
Vehicles with a smart key system: the engine switch is in ignition on mode.
If no washer fluid sprays
Check that the washer nozzle is not blocked if there is washer fluid in the washer fluid reservoir.
Notice
Do not use the wiper, as it may damage the rear window. When the washer fluid tank is empty Do not operate the switch continually as the washer fluid pump may overheat. When a nozzle becomes blocked In this case, contact your toyota dealer. Do not try to clear it with a pin or other object. The nozzle will be damaged. |
Windshield wipers and
washer
RefuelingECM (2AZ-FE)
REPLACEMENT
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE RH (See page 71-10 )
3. REMOVE COWL SIDE TRIM SUB-ASSY RH (See page 71-10 )
4. REMOVE GLOVE COMPARTMENT DOOR ASSY (See page 71-10 )
5. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO.2 (See page 71-10 )
6. REMOV ...