Toyota Highlander Service Manual: Rear axle LH hub bolt
REPLACEMENT
HINT: COMPONENTS:SEE PAGE 30-4 Replace the RH side by the same procedures with the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSY LH (2WD DRIVE TYPE)
(a) Remove the 2 bolts and brake caliper.
(b) Support the brake caliper securely.
3. SEPARATE REAR DISC BRAKE CALIPER ASSY LH (4WD DRIVE TYPE)
4. REMOVE REAR DISC (SEE PAGE 32-29 )
5. REMOVE REAR AXLE LH HUB BOLT
(a) Using SST and a screwdriver or an equivalent to hold, remove the hub bolt.
SST 09628-1001 1
6. INSTALL REAR AXLE LH HUB BOLT
(a) Install a washer and nut to a new hub bolt as shown in the illustration.
(b) Using a screwdriver to hold, install the hub bolt by torquing the nut.
7. INSTALL REAR DISC (SEE PAGE 32-29 )
8. INSTALL REAR DISC BRAKE CALIPER ASSY LH (2WD DRIVE TYPE)
(a) Install the brake caliper with the 2 bolts.
Torque: 2WD: 61.8 NVm (630 kgfVcm, 46 ftVlbf)
9. INSTALL REAR DISC BRAKE CALIPER ASSY LH (4WD DRIVE TYPE)
(a) Install the brake caliper with the 2 bolts.
Torque: 4WD: 58 NVm (592 kgfVcm, 43 ftVlbf)
10. INSTALL REAR WHEEL
Rear axle carrier sub-ASSY LH (4WD)
REPLACEMENT
HINT:
COMPONENTS: SEE PAGE 30-4
Replace the RH side using the same procedures as for the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE SPEED SENSOR REAR LH
(a) Remove the bolt and separa ...
Transfer
...
More about Toyota Highlander:
Inside rear view mirror
The rear view mirror’s position can be adjusted to enable sufficient
confirmation of the rear view.
Adjusting the height of rear view mirror
The height of the rear view mirror can be adjusted to suit your driving
posture.
Adjust the height of the rear view
mirror by moving it up and down.
...
