Toyota Highlander Service Manual: Disposal
1. DISPOSE OF SHOCK ABSORBER ASSY REAR LH

(a) Fully extend the shock absorber rod.
(b) Using a drill, make a hole in the cylinder somewhere between
A and B as shown in the illustration to discharge the
gas inside.
CAUTION:
- Be careful when drilling as shards of metal may fly
about. Always use the proper safety equipment.
- The gas is colorless, odorless and non-poisonous.
HINT:
COMPONENTS: See page 27-2 .
1. REMOVE DECK SIDE TRIM COVER LH
2. REMOVE REAR WHEEL
3. SEPARATE REAR STABILIZER LINK ASSY LH
(a) Support the rear axle carrier with a jack.
(b) Remov ...
HINT:
COMPONENTS: See page 27-2 .
1. REMOVE REAR WHEEL
2. REMOVE STRUT ROD ASSY REAR
(a) Support the rear axle carrier with a jack.
(b) Remove the bolt and nut, and separate the parking b ...
More about Toyota Highlander:
Chassis
ON-VEHICLE INSPECTION
1. INSPECT STEERING LINKAGE
(a) Check the steering linkage for looseness or damage.
Check that:
Tie rod ends do not have excessive play.
Dust seals and boots are not damaged.
Boot clamps are not loose.
(b) Inspect the dust cover for damage.
2. INSPECT STEERING ...
В© 2011-2026 Copyright www.tohighlander.com