Toyota Highlander Service Manual: Disposal

Toyota Highlander Service Manual / Front suspension / Shock absorber ASSY front LH / Disposal

HINT: Dispose of the RH side by following the same procedures as with the LH side.

1. DISPOSE OF SHOCK ABSORBER ASSY FRONT LH

DISPOSE OF SHOCK ABSORBER ASSY FRONT LH

(a) Fully extend the shock absorber rod.

(b) Using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside.

CAUTION:

Be careful when drilling because shards of metal may fly about. Always use the proper safety equipment.
The gas is colorless, odorless and non-poisonous.

Replacement

HINT: COMPONENTS: See page 26-3 Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. REMOVE FRONT WHEEL 2. SEPARATE FRONT STABILIZER LIN ...

Front suspension ARM sub-ASSY lower NO.1 LH

REPLACEMENT HINT: COMPONENTS: See page 26-3 . Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (3MZ-F ...

More about Toyota Highlander:

Stabilizer bar rear (4WD)
REPLACEMENT HINT: COMPONENTS: See page 27-2 . 1. REMOVE REAR WHEEL 2. REMOVE REAR STABILIZER LINK ASSY LH (a) Remove the 2 nuts and stabilizer link. HINT: If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud. 3. REMOVE REAR STABILIZER LINK ASSY RH ...