Toyota Highlander Service Manual: Circuit inspection
How to read and use each page is shown below.
Problem symptoms table
The suspected circuits or parts for each problem symptom are shown in the
table below. Use this table to
troubleshoot when, during a DTC check, a "Normal" code is displayed but the
problem is sti ...
Electronic circuit inspection procedure
1. BASIC INSPECTION
(a) RESISTANCE MEASURING CONDITION OF ELECTRONIC PARTS
Unless stated, all resistance is measured at an ambient
temperature of 20 C (68 F). Resistances
measured may ...
More about Toyota Highlander:
Replacement
1. REMOVE FRONT WHEEL
2. REMOVE ENGINE UNDER COVER NO.1
3. REMOVE FRONT FENDER APRON SEAL RH
4. DRAIN ENGINE OIL
(a) Install a new gasket after draining engine oil.
Torque: 45 NVm (459 kgfVcm, 33 ftVlbf)
5. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(See page 14-125 )
6. R ...
В© 2011-2026 Copyright www.tohighlander.com
