Toyota Highlander Service Manual: Adjustment
1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSY
(a) Apply the parking brake and turn the ignition switch ON.
(b) Depress the brake pedal and check that the engine starts only when the shift lever is set in N or P position and it does not start in other positions.
(c) Check that the back-up light is lit and the reverse warning buzzer sounds only when the shift lever is set in R position and these do not function in other positions.
If a failure is found, check the park/neutral position switch for continuity.
2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSY
(a) Loosen the 2 bolts of park/neutral position switch and set the shift lever to the N position.
(b) Align the groove and neutral basic line.
(c) Hold the switch in position and tighten the 2 bolts.
Torque: 5.4 NVm (55 kgfVcm, 48 in.Vlbf)
(d) After adjustment, perform the inspection described in step 1.
Park/neutral position switch ASSY (U241E/U140F)
REPLACEMENT
1. REMOVE ENGINE UNDER COVER NO.1
2. SEPARATE TRANSMISSION CONTROL CABLE ASSY
(a) Remove the nut from the control shaft lever.
(b) Disconnect the control cable from the control sha ...
More about Toyota Highlander:
On-vehicle inspection
1. CHECK AUTO OPERATION
HINT:
When pressing the switch for 0.3 seconds or less, the roof glass moves but auto
operation does not operate.
(a) Turn the ignition switch ON.
(b) When the roof glass is fully closed, check that pressing the slide roof open
side of the sliding roof switch
for 0.3 ...
