Toyota Highlander Service Manual: Accelerator pedal rod ASSY (3MZ-FE)

Toyota Highlander Service Manual / Engine control system / Accelerator pedal rod ASSY (3MZ-FE)

REPLACEMENT

1. REMOVE ACCELERATOR PEDAL ROD ASSY

Accelerator pedal rod ASSY (3MZ-FE)

(a) Disconnect the accelerator pedal position sensor connector.

(b) Remove the 2 bolts and pedal rod.

2. INSTALL ACCELERATOR PEDAL ROD ASSY

(a) Install the pedal rod with the 2 bolts.

Torque: 4.9 NVm (50 kgfVcm, 43 in.Vlbf) (b) Connect the accelerator pedal position sensor connector.

ECM (3MZ-FE)

REPLACEMENT 1. DISCONNECT BATTERY NEGATIVE TERMINAL 2. REMOVE FRONT DOOR SCUFF PLATE RH (See page 71-10 ) 3. REMOVE COWL SIDE TRIM SUB-ASSY RH (See page 71-10 ) 4. REMOVE GLOVE COMPARTMENT DOOR AS ...

Fuel system (2AZ-FE)

...

More about Toyota Highlander:

Chassis
ON-VEHICLE INSPECTION 1. INSPECT STEERING LINKAGE (a) Check the steering linkage for looseness or damage. Check that: Tie rod ends do not have excessive play. Dust seals and boots are not damaged. Boot clamps are not loose. (b) Inspect the dust cover for damage. 2. INSPECT STEERING ...