Toyota Highlander Service Manual: Speed sensor (U151E/U151F)
REPLACEMENT
1. REMOVE BATTERY
2. REMOVE AIR CLEANER ASSY
3. REMOVE AIR CLEANER HOSE NO.1
4. REMOVE SPEED SENSOR (NT SENSOR)
(a) Disconnect the speed sensor connector.
(b) Remove the bolt and speed sensor.
5. REMOVE SPEED SENSOR (NC SENSOR)
(a) Disconnect the speed sensor connector.
(b) Remove the bolt and speed sensor.
6. INSTALL SPEED SENSOR (NC SENSOR)
(a) Coat the O-ring with ATF.
(b) Install the speed sensor with the bolt.
Torque: 11 NVm (115 kgfVcm, 8 ftVlbf)
HINT: Make sure of the sensor manufacturer's name.
(c) Connect the speed sensor connector.
7. INSTALL SPEED SENSOR (NT SENSOR)
(a) Coat the O-ring with ATF.
(b) Install the speed sensor with the bolt.
Torque: 11 NVm (115 kgfVcm, 8 ftVlbf)
HINT: Make sure of the sensor manufacturer's name.
(c) Connect the speed sensor connector.
8. INSTALL AIR CLEANER HOSE NO.1
9. INSTALL AIR CLEANER ASSY
10. INSTALL BATTERY
11. PERFORM INITIALIZATION(SEE PAGE 01-4 )
Speed sensor (U241E/U140F)
REPLACEMENT
1. REMOVE BATTERY
2. REMOVE AIR CLEANER ASSY
3. REMOVE AIR CLEANER HOSE NO.1
4. REMOVE SPEED SENSOR (NT SENSOR)
(a) Disconnect the connector.
(b) Remove the bolt and speed sensor ...
Transmission wire (U241E/U140F)
REPLACEMENT
1. REMOVE ENGINE UNDER COVER NO.1
2. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and drain plug.
Torque: 49 NVm (500 kg ...
More about Toyota Highlander:
On-vehicle inspection
1. INSPECT TURN SIGNAL FLASHER CIRCUIT
(a) Disconnect the connector from the turn signal flasher
relay.
(b) Measure the voltage according to the value(s) in the table
below.
Standard
(c) Reconnect the connector to the turn signal flasher.
(d) Measure the voltage according to the valve ...