REPLACEMENT
HINT:
1. REMOVE GLOVE COMPARTMENT DOOR ASSY (SEE PAGE 71-10 )
2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO.2 (SEE PAGE 71-10 )
3. REMOVE FRONT PILLAR GARNISH RH (SEE PAGE 71-10 )
4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSY LH (SEE PAGE 76-2 )
5. REMOVE W/HOLDER ANTENNA ASSY

(a) Disconnect the connector,and remove the bolt.
(b) Remove the 2 clamps.

(c) Tie the string at the tip of the cable of the w/holder antenna assy.
(d) Remove the antenna nut and ornament antenna.

(e) Remove the nut and w/holder antenna assy.
6. INSTALL W/HOLDER ANTENNA ASSY
(a) Install the w/holder antenna assy with the nut.
(b) Install the antenna nut and ornament antenna.
(c) Use the string to put the cable of the w/holder antenna assy.
(d) Install the 2 clamps.
(e) Connect the connector, install the bolt.
Amplifier antenna ASSY
Navigation antenna ASSYInspection
1. INSPECT FUEL INJECTOR ASSY
(a) Check the injector resistance.
Measure the resistance between the terminals.
Standard: 11.6 to 12.4 W at 20 C (68 F)
If the result is not as specified, replace the injector.
(b) Check the injector injection.
CAUTION:
This test involves high-pre ...