Toyota Highlander Service Manual: Speed sensor front LH
REPLACEMENT
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSY LH
3. REMOVE SPEED SENSOR FRONT LH
(a) Disconnect the speed sensor connector.
(b) Remove the 2 bolts and the clamp from the body and the shock absorber assy.
(c) Remove the bolt and the speed sensor front.
NOTICE: Prevent foreign matter from attaching to the sensor tip.
4. INSTALL SPEED SENSOR FRONT LH
(a) Install the speed sensor front with the bolt.
Torque: 8.0 NVm (82 kgfVcm, 71 in.Vlbf)
NOTICE: Prevent foreign matter from attaching to the sensor tip.
(b) Install the speed sensor front with the 2 bolts and the clamp.
Torque: Bolt A: 5.0 NVm (51 kgfVcm, 44 in.Vlbf) Bolt B: 19 NVm (192 kgfVcm, 14 ftVlbf)
NOTICE: Do not twist the sensor wire when installing the sensor.
(c) Connect the speed sensor connector.
5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSY LH
6. INSTALL FRONT WHEEL
Torque: 103 NVm (1,050 kgfVcm, 76 ftVlbf)
7. CHECK ABS SPEED SENSOR SIGNAL (SEE PAGE 05-765 )
Replacement
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. DRAIN BRAKE FLUID
NOTICE:
Wash brake fluid off immediately if it adheres to any painted surface.
3. REMOVE BRAKE ACTUATOR WITH BRACKET
(a) Using SST ...
Skid control sensor (FF)
REPLACEMENT
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. REMOVE REAR WHEEL
2. DISCONNECT SKID CONTROL SENSOR WIRE
(a) Disc ...
More about Toyota Highlander:
Crankshaft position sensor (2AZ-FE)
REPLACEMENT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (see
page 03-2 ).
1. REMOVE ENGINE UNDER COVER NO.1
(a) Remove the 6 screws, 2 clips and under cover
2. REMOVE FRONT FENDER APRON SEAL RH
(a) Remove the clip, 2 bolts and apron seal.
3. REMOV ...
