Toyota Highlander Service Manual: On-vehicle inspection
Toyota Highlander Service Manual / Emission control / Intake air control system (3MZ-FE) / On-vehicle inspection
1. INSPECT INTAKE AIR CONTROL SYSTEM
(a) Using a 3-way connector, connect a vacuum gauge to the actuator hose.
(b) Connect the hand-held tester to the DLC3.
(c) Start the engine.
(d) On the hand-held tester, enter the ACTIVE TEST mode.
Standard:
Inspection
1. INSPECT INTAKE AIR CONTROL VALVE ASSY NO.2
(a) Apply 26.7 kPa (200 mmHg, 7.9 in.Hg) of vacuum to the
actuator. Check if the actuator rod pulls the lever and
causes the valve to rotate open, ...
More about Toyota Highlander:
On-vehicle inspection
CAUTION:
Be sure to perform the initialization of the occupant classification ECU if any
of the following conditions
occur (see page 05-1207 ). If the initialization is not performed, the SRS may
not operate properly.
The occupant classification ECU is replaced.
Accessories (seatback tr ...
В© 2011-2026 Copyright www.tohighlander.com
