The vehicle’s keys have built-in transponder chips that prevent the engine from starting if a key has not been previously registered in the vehicle’s on-board computer.
Never leave the keys inside the vehicle when you leave the vehicle.
This system is designed to help prevent vehicle theft but does not guarantee absolute security against all vehicle thefts.
Vehicles without a smart key system: the indicator light flashes after the key has been removed from the engine switch to indicate that the system is operating.
The indicator light stops flashing after the registered key has been inserted into the engine switch to indicate that the system has been canceled.
Vehicles with a smart key system: the indicator light flashes after the engine switch has been turned off to indicate that the system is operating.
The indicator light stops flashing after the engine switch has been turned to accessory or ignition on mode to indicate that the system has been canceled.
System maintenance
The vehicle has a maintenance-free type engine immobilizer system.
Conditions that may cause the system to malfunction
Certification for the engine immobilizer system
Fcc id: wrkri-44bty fcc id: ni4tmimb-3 this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Fcc warning changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
this device complies with industry canada licence-exempt rss standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Notice
Do not modify or remove the system. If modified or removed, the proper operation of the system cannot be guaranteed. |
Strut rod ASSY rear
HINT:
COMPONENTS: See page 27-2 .
1. REMOVE REAR WHEEL
2. REMOVE STRUT ROD ASSY REAR
(a) Support the rear axle carrier with a jack.
(b) Remove the bolt and nut, and separate the parking brake
cable.
(c) Remove the bolt and nut, and disconnect the strut rod
(front side).
NOTICE:
...