Toyota Highlander Service Manual: Crankshaft position sensor (3MZ-FE)
REPLACEMENT
HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ).
1. REMOVE ENGINE UNDER COVER NO.1
(a) Remove the 6 screws, 2 clips and under cover.
2. REMOVE FRONT FENDER APRON SEAL RH
(a) Remove the clip, 2 bolts and apron seal.
3. REMOVE CRANKSHAFT POSITION SENSOR
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
4. INSTALL CRANKSHAFT POSITION SENSOR
(a) Install the sensor with the bolt.
Torque: 8.0 NVm (82 kgfVcm, 71 in.Vlbf) (b) Connect the sensor connector.
5. INSTALL FRONT FENDER APRON SEAL RH
(a) Install the clip, 2 bolts and apron seal.
6. INSTALL ENGINE UNDER COVER NO.1
(a) Install the 6 screws, 2 clips and under cover.
VVT sensor (3MZ-FE)
REPLACEMENT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (see
page 03-2 ).
1. REMOVE AIR CLEANER ASSY
2. REMOVE VVT SENSOR
(a) Disconnect the sensor conne ...
More about Toyota Highlander:
Stabilizer bar front (4WD)
REPLACEMENT
HINT:
COMPONENTS: See page 28-1 .
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT STABILIZER LINK ASSY LH
(a) Remove the 2 nuts and the front stabilizer link assy LH.
HINT:
If ...
