Toyota Highlander Service Manual: Charging system (3MZ-FE)
1. REMOVE MAGNETIC SWITCH ASSY
(a) Remove the nut and disconnect the lead wire from the
magnetic switch.
(b) Remove the 2 screws holding the magnetic switch to the
starter drive housing.
...
CAUTION:
Check that the battery cables are connected to the correct terminals.
Disconnect the battery cables when the battery is given a quick
charge.
Do not perform tests with a high volta ...
More about Toyota Highlander:
Speed sensor rear LH (4WD)
REPLACEMENT
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. REMOVE DECK TRIM SIDE PANEL ASSY LH (SEE PAGE 76-21 )
2. REMOVE REAR WHEEL
3. REMOVE SPEED SENSOR REAR LH
(a) Disconnect the speed sensor connector.
NOTICE:
B ...
В© 2011-2026 Copyright www.tohighlander.com