Toyota Highlander Owners Manual: Canceling and resuming the speed control

Toyota Highlander Owners Manual / Driving / Using the driving support systems / Dynamic radar cruise control / Canceling and resuming the speed control

Pulling the lever toward you cancels the cruise control.
The speed setting is also canceled when the brakes are applied.
Pushing the lever up resumes the cruise control and returns vehicle speed to the set speed.
Resuming is available when the vehicle speed is more than approximately 25 mph (40 km/h).

Toyota Highlander. Canceling and resuming the speed control

Changing the vehicle-to-vehicle distance

Pressing the button changes the vehicle-to-vehicle distance as follows: long medium short The vehicle-to-vehicle distance is set automatically to long mode when the engine switch is ...

Driving in vehicle-to-vehicle distance control mode

This mode employs a radar sensor to detect the presence of vehicles up to approximately 400 ft. (120 M) ahead, determines the current vehicle-to-vehicle following distance, and operates to maintain ...

More about Toyota Highlander:

Speed sensor rear LH (4WD)
REPLACEMENT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. REMOVE DECK TRIM SIDE PANEL ASSY LH (SEE PAGE 76-21 ) 2. REMOVE REAR WHEEL 3. REMOVE SPEED SENSOR REAR LH (a) Disconnect the speed sensor connector. NOTICE: B ...