Toyota Highlander Service Manual: Camshaft position sensor (2AZ-FE)
REPLACEMENT
HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ).
1. REMOVE AIR CLEANER ASSY (See page 14-24 )
2. REMOVE CAMSHAFT POSITION SENSOR
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
3. INSTALL CAMSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to a new O-ring. Install the O-ring onto the sensor.
(b) Install the sensor with the bolt.
Torque: 9.0 NVm (92 kgfVcm, 80 in.Vlbf)
4. INSTALL AIR CLEANER ASSY (See page 14-24 )
Inspection
NOTICE:
In this section, the terms "cold"and "hot" refer to the temperature of the
coils. "Cold" means approximately
-10 C (14 F) to 50 C (122 F). "Hot" means approximately 50 C (122 F) to 100 C
...
Crankshaft position sensor (2AZ-FE)
REPLACEMENT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (see
page 03-2 ).
1. REMOVE ENGINE UNDER COVER NO.1
(a) Remove the 6 screws, 2 clips and under cov ...
More about Toyota Highlander:
Cruise control
CRUISE CONTROL MAIN SWITCH
REPLACEMENT
HINT:
Installation is in the reverse order of removal.
1. PRECAUTION (SEE PAGE 60-1 )
2. DISCONNECT BATTERY NEGATIVE TERMINAL (SEE PAGE 60-1 )
3. REMOVE STEERING WHEEL COVER LOWER NO.2
4. REMOVE STEERING WHEEL COVER LOWER NO.3
5. REMOVE HORN BUTTON ASSY ...
