Toyota Highlander Service Manual: Body
ON-VEHICLE INSPECTION
1. Canada: TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
(a) Where necessary, tighten all the parts of the chassis.
- Front axle and suspension
- Drive train
- Rear axle and suspension
- Brake system
- Engine mounting, etc.
(b) Where necessary, tighten all the parts of the body.
- Seat belt system
- Seats
- Doors and hood
- Body mountings
- Fuel tank
- Exhaust pipe system, etc.
2. REPLACE AIR CONDITIONING FILTER
(a) Remove the glove compartment assembly.
(b) Remove the filter case by holding both sides.
(c) Remove the filter from the filter case.
(d) Replace the filter with a new one.
(e) The installation is in the reverse order of the removal.
Chassis
ON-VEHICLE INSPECTION
1. INSPECT STEERING LINKAGE
(a) Check the steering linkage for looseness or damage.
Check that:
Tie rod ends do not have excessive play.
Dust seals and boots are not d ...
More about Toyota Highlander:
Thermostat (2AZ-FE)
REPLACEMENT
1. DRAIN ENGINE COOLANT (See page 16-6 )
2. REMOVE FAN AND GENERATOR V BELT (See page 14-5 )
3. REMOVE GENERATOR ASSY (See page 19-16 )
4. DISCONNECT RADIATOR HOSE INLET
5. REMOVE WATER INLET
(a) Remove the 2 nuts and disconnect the water inlet from
the cylinder block.
6. REM ...
