Toyota Highlander Service Manual: Terminals of ECU
Toyota Highlander Service Manual / Sliding roof/convertible / Sliding roof system / Terminals of ECU
1. CHECK SLIDING ROOF DRIVE GEAR SUB- ASSY (SLIDING ROOF ECU)
(a) Disconnect the sliding roof ECU connector, and check the voltage or continuity of each terminal of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness.
Location
HOW TO PROCEED WITH TROUBLESHOOTING
HINT:
Troubleshoot in accordance with the procedures on the following pages.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
3 PROBLEM SYMPTOM CONF ...
Data list/active test
1. CHECK USING INTELLIGENT TESTER
(a) Connect the intelligent tester to the DLC3.
(b) Select the DATA LIST mode on the intelligent tester.
Sliding roof ECU:
(c) The active test will indicate i ...
More about Toyota Highlander:
Air conditioning controls
Adjusting the temperature setting
To adjust the temperature setting, turn
clockwise to increase
the temperature and counterclockwise to decrease the temperature.
The temperature for the driver, front passenger and rear seats can be
adjusted separately when:
is pressed. (The
...
В© 2011-2026 Copyright www.tohighlander.com
