Toyota Highlander manuals

Toyota Highlander Owners Manual: Settings display

Changing the settings

  1. Select using
    the meter control switches.
  2. Select an item and then set it with the center button.

Customizable items

Settings can be changed. (Customizable features: ) *: Speed limit display may not be available for some regions.

In some situations, such as when a switch operation is performed, a pop-up display, such as the operating cruise control switch, will be temporarily displayed on the multi-information display.

The pop-up display function can be set on/off.

In the following situations, setting display in which the settings can be changed through the meter control switch will automatically be turned off.

Small spots or light spots may appear on the display. This phenomenon is characteristic of liquid crystal displays, and there is no problem continuing to use the display.

Warning


The information display at low temperatures

Allow the interior of the vehicle to warm up before using the liquid crystal information display. At extremely low temperatures, the display monitor may respond slowly, and display changes may be delayed.

For example, there is a lag between the driver's shifting and the new gear number appearing on the display. This lag could cause the driver to downshift again, causing rapid and excessive engine braking and possibly an accident resulting in death or injury.

Cautions during setting up the display

As the engine needs to be running during setting up the display, ensure that the vehicle is parked in a place with adequate ventilation. In a closed area such as a garage, exhaust gases including harmful carbon monoxide (co) may collect and enter the vehicle. This may lead to death or a serious health hazard.

 

Notice


During setting up the display

To prevent battery discharge, Ensure that the engine is running while setting up the display features.

Drive information
Current fuel consumption*1 displays the current rate of fuel consumption  average fuel economy (after reset*2/after start/after refuel)*1 displays the average fuel economy since the func ...

Eco driving indicator
Eco driving indicator light During eco-friendly acceleration operation (eco driving), eco driving indicator light will turn on. When the acceleration exceeds zone of eco driving, and when the ...

More about Toyota Highlander:

On-vehicle inspection
1. CONNECT HAND-HELD TESTER: (a) Connect the hand-held tester to the DLC3. (b) Start the engine and run at idle. (c) Select the ACTIVE TEST mode on the hand-held tester. HINT: Please refer to the hand-held tester operator's manual for further details. 2. INSPECT ACTUATOR MOTOR OPERATION ...

В© 2011-2019 Copyright www.tohighlander.com