Toyota Highlander Service Manual: Accelerator pedal rod ASSY (2AZ-FE)
Toyota Highlander Service Manual / Engine control system / Accelerator pedal rod ASSY (2AZ-FE)
REPLACEMENT
1. REMOVE ACCELERATOR PEDAL ROD ASSY
(a) Disconnect the accelerator pedal position sensor connector.
(b) Remove the 2 bolts and pedal rod.
2. INSTALL ACCELERATOR PEDAL ROD ASSY
(a) Install the pedal rod with the 2 bolts.
Torque: 4.9 NVm (50 kgfVcm, 43 in.Vlbf) (b) Connect the acceleator pedal position sensor connector
ECM (2AZ-FE)
REPLACEMENT
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE RH (See page 71-10 )
3. REMOVE COWL SIDE TRIM SUB-ASSY RH (See page 71-10 )
4. REMOVE GLOVE COMPARTMENT DOOR AS ...
More about Toyota Highlander:
The rear cross traffic alert function detection areas
The areas that vehicles can be detected in are outlined below.
To give the driver a more consistent time to react, the buzzer can alert
for faster vehicles from farther away.
Example:
The rear cross traffic alert function is operational when
The bsm main switch is set to on.
The ...
В© 2011-2026 Copyright www.tohighlander.com
