Toyota Highlander Service Manual: VVT sensor (3MZ-FE)
REPLACEMENT
HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ).
1. REMOVE AIR CLEANER ASSY
2. REMOVE VVT SENSOR
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
3. INSTALL VVT SENSOR
(a) Apply a light coat of engine oil to a new O-ring. Install the O-ring onto the sensor.
(b) Install the sensor with the bolt.
Torque: 8.0 NVm (82 kgfVcm, 71 in.Vlbf) (c) Connect the sensor connector.
4. INSTALL AIR CLEANER ASSY (See page 14-24 )
Inspection
NOTICE:
In this section, the terms "cold" and "hot" refer to the temperature of the
coils. "Cold" means approximately
-10 C (14 F) to 50 C (122 F). "Hot" means approximately 50 C (122 F) to 100 C ...
Crankshaft position sensor (3MZ-FE)
REPLACEMENT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (see
page 03-2 ).
1. REMOVE ENGINE UNDER COVER NO.1
(a) Remove the 6 screws, 2 clips and under cov ...
More about Toyota Highlander:
Memory recall function
Each electronic key can be registered to recall your preferred driving
position.
Registering procedure
Record your driving position to button “1” or “2” before performing
the following:
carry only the key you want to register, and then close the driver’s
door.
If 2 or more k ...
