Toyota Highlander manuals

Toyota Highlander Service Manual: Transmission control cable ASSY (ATM)

Toyota Highlander Service Manual / Automatic transmission / trans / Transmission control cable ASSY (ATM)

REPLACEMENT

1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSY CENTER (SEE PAGE 71-10 )

2. REMOVE FLOOR CARPET COVER CENTER RH (SEE PAGE 71-10 )

3. REMOVE FLOOR CARPET COVER CENTER LH (SEE PAGE 71-10 )

4. REMOVE BATTERY

5. REMOVE AIR CLEANER ASSY

6. REMOVE AIR CLEANER HOSE NO.1

7. REMOVE TRANSMISSION CONTROL CABLE ASSY

REMOVE TRANSMISSION CONTROL CABLE ASSY


(a) Remove the nut from the control shaft lever.

(b) Disconnect the control cable from the control shaft lever.

REMOVE TRANSMISSION CONTROL CABLE ASSY


(c) Remove the clip and disconnect the control cable from the control cable bracket.

REMOVE TRANSMISSION CONTROL CABLE ASSY


(d) Disconnect the control cable from the control cable clamp.

REMOVE TRANSMISSION CONTROL CABLE ASSY


(e) Disconnect the cable end from the rod of the floor shift assy.

REMOVE TRANSMISSION CONTROL CABLE ASSY


(f) Remove the 2 nuts.

REMOVE TRANSMISSION CONTROL CABLE ASSY


(g) Remove the 3 bolts.

(h) Pull out the control cable from the body.

8. INSTALL TRANSMISSION CONTROL CABLE ASSY

INSTALL TRANSMISSION CONTROL CABLE ASSY


(a) Pull in the control cable to the body.

(b) Install the 3 bolts.

Torque: 4.9 NVm (50 kgfVcm, 43 in.Vlbf)

INSTALL TRANSMISSION CONTROL CABLE ASSY


(c) Install the cable end, as shown in the illustration.

HINT: Install it with the uneven surface facing up.

INSTALL TRANSMISSION CONTROL CABLE ASSY


(d) Install the control cable and 2 nuts.

Torque: 11.8 NVm (122 kgfVcm, 9 ftVlbf)

INSTALL TRANSMISSION CONTROL CABLE ASSY


(e) Connect the control cable to the control cable clamp.

INSTALL TRANSMISSION CONTROL CABLE ASSY


(f) Temporarily install the control cable to the control shaft lever with nuts.

INSTALL TRANSMISSION CONTROL CABLE ASSY


(g) Install the control cable and clip to the bracket.

9. INSTALL AIR CLEANER ASSY

10. ADJUST SHIFT LEVER POSITION (SEE PAGE 40-71 )

11. INSPECT SHIFT LEVER POSITION (SEE PAGE 40-71 )

Key inter lock solenoid (ATM)
INSPECTION 1. INSPECT KEY INTER LOCK SOLENOID (a) Disconnect the solenoid connector. (b) Connect KLS+ (4) terminal to the batteries' positive (+) terminal, and KLS- (3) terminal to the battery ...

Steering column
...

More about Toyota Highlander:

Replacement
1. DISCHARGE FUEL SYSTEM PRESSURE (See page 11-35 ) 2. DRAIN ENGINE COOLANT (See page 16-26 ) 3. REMOVE FRONT SUSPENSION BRACE SUB-ASSY UPPER CENTER (w/ Performance Rod) (a) Remove the 2 nuts and upper brace. 4. REMOVE V-BANK COVER SUB-ASSY (See page 14-149 ) 5. REMOVE AIR CLEANER CAP SUB-ASS ...

В© 2011-2024 Copyright www.tohighlander.com