ADJUSTMENT
1. REMOVE EXHAUST PIPE ASSY FRONT (3MZ-FE ENGINE TYPE) (SEE PAGE 15-5 )
2. REMOVE EXHAUST PIPE ASSY FRONT (2AZ-FE ENGINE TYPE) (SEE PAGE 15-2 )
3. INSPECT TRANSFER OIL
(a) Remove the No.1 plug and gasket.
(b) Check the oil level is within 0 to 5 mm (0 to 0.1968 in.) down from the lowest end of the hole for No.1 plug.
NOTICE:
(c) When the oil level is too low, check for oil leakage.
(d) Tighten the No.1 plug with a new gasket.
Torque: 49 NVm (500 kgfVcm, 36 ftVlbf)
4. ADD TRANSFER OIL
(a) Remove the No.1 plug and gasket and supply oil.
NOTICE:
HINT: Within 0 to 5 mm (0 to 0.1968 in.) down from the lowest end of the hole for the No.1 plug.
(b) After leaving it alone for 5 min., check the oil level again.
(c) Tighten the No. 1 plug with a new gasket.
5. INSTALL EXHAUST PIPE ASSY FRONT (3MZ-FE ENGINE TYPE) (SEE PAGE 15-5 )
6. INSTALL EXHAUST PIPE ASSY FRONT (2AZ-FE ENGINE TYPE) (SEE PAGE 15-2 )
Stowing the flat tire, jack and all tools (with a compact spare tire)
Remove the center wheel ornament by pushing from the reverse
side.
Be careful not to lose the wheel ornament.
Stand the tire against the
bumper with the inner surface
facing toward you. Pass the
hoist assembly (c) and holding
bracket (b) through the wheel
opening.
Fully ...