COMPONENTS
REPLACEMENT
1. DRAIN ENGINE COOLANT (See page 16-6 )
2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE (See page 14-24 )
3. REMOVE THROTTLE BODY ASSY
(a) Disconnect the throttle control motor & throttle position sensor connector.
(b) Disconnect the vacuum hose from the throttle body.
(c) Disconnect the 2 water by-pass hoses.
(d) Remove the 4 bolts, fuel pipe support and throttle body.
(e) Remove the gasket.
4. INSTALL THROTTLE BODY ASSY
(a) Install a new gasket to the intake manifold, as shown in the illustration.
(b) Install the throttle body and fuel pipe support with the 4 bolts.
Torque: 30 NVm (305 kgfVcm, 22 ftVlbf) (c) Connect the 2 water by-pass hoses to the throttle body.
(d) Connect the throttle control motor & throttle position sensor connector.
(e) Connect the vacuum hose to the throttle body.
5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE (See page 14-24 )
6. ADD ENGINE COOLANT (See page 16-6 )
7. CHECK FOR ENGINE COOLANT LEAKS (See page 16-1 )
If the engine will not
start
If the engine will not start even though correct starting procedures
are being followed , Consider each of the following
points:
The engine will not start even though the starter motor operates
normally.
One of the following may be the cause of the problem:
there may not be sufficient ...