Toyota Highlander manuals

Toyota Highlander Service Manual: Starting & charging

Toyota Highlander Service Manual / Starting & charging

Crankshaft position sensor (3MZ-FE)
REPLACEMENT HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ). 1. REMOVE ENGINE UNDER COVER NO.1 (a) Remove the 6 screws, 2 clips and under cov ...

Starting system (2AZ-FE)
INSPECTION 1. INSPECT STARTER ASSY NOTICE: These tests must be performed within 3 to 5 seconds to avoid burning out the coil. (a) Do the pull-in test.  Disconnect the lead wire from ...

More about Toyota Highlander:

Inspection
1. INSPECT GARAGE DOOR OPENER (a) Press the switch and check that each red LED turns on. If one or more of the switches does not turn on the LED, confirm normal operation of the fuse and wire harness, then replace the garage door opener. 2. INSPECT GARAGE DOOR OPENER REGISTRATION AND TRAN ...

В© 2011-2026 Copyright www.tohighlander.com