Toyota Highlander manuals

Toyota Highlander Service Manual: Speed sensor rear LH (4WD)

Toyota Highlander Service Manual / Brake / Speed sensor rear LH (4WD)

REPLACEMENT

HINT:

1. REMOVE DECK TRIM SIDE PANEL ASSY LH (SEE PAGE 76-21 )

2. REMOVE REAR WHEEL

3. REMOVE SPEED SENSOR REAR LH

REMOVE SPEED SENSOR REAR LH


(a) Disconnect the speed sensor connector.

NOTICE: Be careful not to damage the wire harness.

REMOVE SPEED SENSOR REAR LH


(b) Pull out the sensor wire harness with the grommet.

NOTICE: Do not pull sensor wire.

(c) Remove the 2 bolts holding the sensor harness from the body and the shock absorber assy.

REMOVE SPEED SENSOR REAR LH


(d) Remove the bolt and the speed sensor rear.

NOTICE: Prevent foreign matter from attaching to the sensor tip.

4. INSTALL SPEED SENSOR REAR LH

INSTALL SPEED SENSOR REAR LH


(a) Install the speed sensor rear with the bolt.

Torque: 8.0 NVm (82 kgfVcm, 71 in.Vlbf)

NOTICE: Prevent foreign matter from attaching to the sensor tip.

INSTALL SPEED SENSOR REAR LH


(b) Install the sensor harness clamps with the 2 bolts to the body and the shock absorber assy.

Torque: 5.0 NVm (51 kgfVcm, 44 in.Vlbf)

NOTICE: Do not twist the sensor wire when installing the sensor.

(c) Push in the sensor wire harness with grommet.

NOTICE: When grommet is set to body, pull the grommet. Do not pull sensor wire.

INSTALL SPEED SENSOR REAR LH


(d) Connect the speed sensor connector.

5. INSTALL REAR WHEEL

Torque: 103 NVm (1,050 kgfVcm, 76 ftVlbf)

6. INSTALL DECK TRIM SIDE PANEL ASSY LH

7. CHECK ABS SPEED SENSOR SIGNAL (SEE PAGE 05-765 )

Skid control sensor (FF)
REPLACEMENT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. REMOVE REAR WHEEL 2. DISCONNECT SKID CONTROL SENSOR WIRE (a) Disc ...

Yawrate sensor
REPLACEMENT NOTICE: Do not use the yawrate sensor if it is dropped or damaged. Prevent foreign matter from attaching between the yawrate sensor bracket and body. Confirm the sensor directi ...

More about Toyota Highlander:

Center stop lamp ASSY
REPLACEMENT HINT: Installation is in the reverse order of removal. 1. REMOVE BACK WINDOW PANEL TRIM UPPER (SEE PAGE 75-20 ) 2. REMOVE CENTER STOP LAMP SOCKET & WIRE (a) Disconnect the connector, and remove the center stop lamp socket & wire. 3. REMOVE CENTER STOP LAMP ASSY (a) Rem ...

В© 2011-2024 Copyright www.tohighlander.com