Toyota Highlander Service Manual: Roof drip side finish moulding center LH

Toyota Highlander Service Manual / Exterior/interior trim / Roof drip side finish moulding center LH

REPLACEMENT

HINT:

The installation is in the reverse order of the removal. However, when there is a special point concerning the installation, it is indicated.
On the RH side, use the same procedures as on the LH side.

1. REMOVE ROOF DRIP SIDE FINISH MOULDING CENTER LH

REMOVE ROOF DRIP SIDE FINISH MOULDING CENTER LH

(a) Cover the circumference of the moulding with protective tape for protection.

(b) Using a remover for the roof moulding, release the engagements of the clips in both front and rear ends of the moulding, and then remove the moulding.

NOTICE:

Do not remove the clips.
In case that the clips are damaged or removed accidentally, exchange them for supplied ones.

2. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP NO.2

NOTICE: Only when exchanging the clips.

(a) Remove the adhesive tape that remains on the mounting surface of the body, and then clean the surface with white gasoline.

(b) Using a heat light, heat up the clip installation surfaces of the body and moulding.

Heating temperature:

INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP NO.2

NOTICE: Do not heat the body and moulding excessively.

(c) Set the supplied clips into the positions as shown in the illustration, and press-fit those clips by hand to install them.

(d) Install the moulding when 30 minutes or more have passed after press-fitting the clips.

HINT:

Initial hardening time: 30 minutes
Prefect hardening time: 24 hours

INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP NO.2

Outside moulding

REPLACEMENT HINT: The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included. Use the same ...

Roof headlining ASSY

COMPONENTS REPLACEMENT HINT: The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are includ ...

More about Toyota Highlander:

Ventilation valve Sub-ASSY (2AZ-FE)
REPLACEMENT 1. REMOVE VENTILATION VALVE SUB-ASSY (a) Disconnect the ventilation hose from the ventilation valve. (b) Remove the ventilation valve. 2. INSTALL VENTILATION VALVE SUB-ASSY (a) Install the ventilation valve. Apply adhesive to 2 or 3 threads. Adhesive: Part No. 0883 ...