Toyota Highlander Service Manual: Replacement
1. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Loosen bolt A.
(b) Loosen bolt B.
(c) Loosen bolt C and remove the V belt.
2. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Temporarily install the V belt as illustrated.
3. ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Apply drive belt tension by turning bolt C.
Drive belt tension: New belt: 160 to 180 lbf Used belt: 115 to 135 lbf
NOTICE:
- "New V belt" refers to a belt which has been used for less than 5 minutes on a running engine.
- "Used V belt" refers to a belt which has been used for 5 minutes or more on a running engine.
- After installing the V belt, check that it fits properly in the ribbed grooves.
4. FULLY TIGHTEN V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Tighten bolt A.
Torque: 58 NVm (591 kgfVcm, 43 ftVlbf) (b) Tighten bolt B.
Torque: 18 NVm (183 kgfVcm, 13 ftVlbf)
Inspection
1. INSPECT V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Belt tension:
Using a belt tension gauge, check the V belt tension
NOTICE:
Check the V belt deflection at the spe ...
Adjustment
1. ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Loosen bolt A.
(b) Loosen bolt B.
(c) Apply drive belt tension by turning bolt C.
Drive belt tension:
New belt: 160 to 180 l ...
More about Toyota Highlander:
If you think something
is wrong
If you notice any of the following symptoms, your vehicle probably
needs adjustment or repair. Contact your toyota dealer as
soon as possible.
Visible symptoms
Fluid leaks under the vehicle.
(Water dripping from the air conditioning after use is normal.)
Flat-looking tires or unev ...
