Toyota Highlander Service Manual: Replacement
NOTICE: Before changing the starter, check the following again:
- Connector connection
- Accessory installation
1. REMOVE BATTERY
2. REMOVE BATTERY TRAY
3. REMOVE STARTER ASSY
(a) Disconnect the starter connector.
(b) Open the terminal cap, remove the nut and disconnect the starter wire.
(c) Remove the 2 bolts and starter.
4. INSTALL STARTER ASSY
(a) Install the starter with the 2 bolts.
Torque: 37 NVm (377 kgfVcm, 27 ftVlbf) (b) Install the starter wire with the nut.
Torque: 9.8 NVm (100 kgfVcm, 7 ftVlbf) (c) Connect the starter connector.
5. INSTALL BATTERY TRAY
6. INSTALL BATTERY
(a) Install the battery clamp with the bolt and nut.
Torque: 5.5 NVm (56 kgfVcm, 49 inVlbf) (b) Connect the cables to the battery terminals.
Torque: 3.5 NVm (36 kgfVcm, 31 in.Vlbf)
Starter ASSY (2AZ-FE)
COMPONENTS
...
Overhaul
1. REMOVE MAGNETIC SWITCH ASSY
(a) Remove the nut and disconnect the lead wire from the
magnetic switch.
(b) Remove the 2 screws holding the magnetic switch to the
starter drive housing.
(c ...
More about Toyota Highlander:
Parking brake system
PROBLEM SYMPTOMS TABLE
Use the table below to help find the cause of the problem. The numbers
indicate the priority of the likely cause
of the problem. Check each part in order. If necessary, replace these parts.
Symptom
Suspect Area
Brake drag
Parking bra ...
