Toyota Highlander Service Manual: Rear door belt moulding ASSY LH
Toyota Highlander Service Manual / Exterior/interior trim / Rear door belt moulding ASSY LH
REPLACEMENT
HINT:
- The installation procedures are the removal procedures in reverse order.
- Use the same procedures for the RH side and LH side.
1. REMOVE DOOR PULL HANDLE (See page 75-13 )
2. REMOVE REAR DOOR TRIM BOARD SUB-ASSY LH (See page 75-13 )
3. REMOVE REAR DOOR BELT MOULDING ASSY LH
(a) Remove the screw.
(b) Put protective tape under the moulding.
(c) Using a moulding remover or scraper, remove the moulding.
Front door belt moulding ASSY LH
REPLACEMENT
HINT:
The installation procedures are the removal procedures in reverse
order.
Use the same procedures for the RH side and LH side.
1. REMOVE POWER WINDOW REGULATOR SWITCH ASS ...
Luggage compartment door garnish sub-ASSY
outside
REPLACEMENT
1. REMOVE BACK WINDOW PANEL TRIM UPPER (See page 75-20 )
2. REMOVE BACK DOOR TRIM COVER RH (See page 75-20 )
3. REMOVE BACK DOOR TRIM COVER LH (See page 75-20 )
4. REMOVE BACK DOOR TRI ...
More about Toyota Highlander:
Changing engine switch modes
Modes can be changed by pressing the engine switch with brake
pedal released. (The mode changes each time the switch is pressed.)
Off*
the emergency flashers can be
used.
The multi-information display will
not be displayed.
Accessory mode
some electrical components such
as the pow ...
В© 2011-2024 Copyright www.tohighlander.com
