Toyota Highlander Service Manual: Problem symptoms table
Use the table below to help determine the cause of the problem. The causes of
problem are listed
in order of probability in the "Suspected Area" column. Check each part in
order. If necessary, replace
these parts.
Symptom |
Suspected Area |
Wander |
- Wheel alignment (Front)
- Wheel alignment (Rear)
- Steering linkage (Loosen or worn)
- Hub bearing (Worn)
- Stabilizer bar (Front [2WD])
- Stabilizer bar (Front [4WD])
- Stabilizer bar (Rear [2WD])
- Stabilizer bar (Rear [4WD])
|
Front wheel shimmy |
- Wheel balance
- Shock absorber (Front)
- Shock absorber (Rear)
- Ball joint (Worn)
- Hub bearing (Worn)
|
Noise (Front drive shaft) |
- Inboard or outboard joint (Worn) (2WD)
- Inboard or outboard joint (Worn) (4WD)
|
Noise (Rear drive shaft) |
- Inboard or outboard joint (Worn)
|
Noise (Propeller shaft) |
- Sleeve yoke spline (Worn)
- Center support bearing (Worn)
- Spider bearing (Worn or stuck)
|
Vibration (Propeller shaft) |
- Propeller and intermediate shafts (Runout)
- Propeller shafts (Imbalance)
- Front flange (Runout)
- Rear flange (Runout)
- Universal joint (Stuck or damaged)
- Sleeve yoke spline (Stuck)
|
PRECAUTION
1. NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSY RH
(a) When removing and installing the front drive shaft assy RH in a 4WD
vehicle, be sure to first drain all
the transaxle ...
1. INSPECT FRONT AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator, check for looseness near the center
of the axle hub.
Maximum: 0 mm (0 in.)
If looseness exceeds the maximum, replace the ...
More about Toyota Highlander:
Fuel injector ASSY (2AZ-FE)
COMPONENTS
REPLACEMENT
1. WORK FOR PREVENTING GASOLINE FROM SPILLING OUT (See page 11-1 )
2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
3. REMOVE ENGINE COVER SUB-ASSY NO.1
4. DISCONNECT FUEL TUBE SUB-ASSY (See page 16-6 )
5. REMOVE FUEL DELIVERY PIPE W/INJECTOR
NOTICE:
Be careful no ...
В© 2011-2024 Copyright www.tohighlander.com