Toyota Highlander Service Manual: Overhaul
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Installation is in the reverse order of removal.
1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSY LH (SEE PAGE 76-2 )
2. REMOVE FOG LAMP PROTECTOR LH
(a) Disengage the 2 claws, and remove the fog lamp protector RH.
3. REMOVE FOG LAMP ASSY LH
(a) Disconnect the connector.
(b) Disengage the 3 claws, and remove the fog lamp assy LH.
4. REMOVE FOG LAMP BULB
(a) Remove the fog lamp bulb as shown in the illustration.
5. REMOVE BEARING FOG LAMP
6. REMOVE FOG LAMP LAMP UNIT LH
7. VEHICLE PREPARATION FOR FOGLAMP AIM ADJUSTMENT (SEE PAGE 65-19 )
8. PREPARATION FOR FOGLAMP AIMING (SEE PAGE 65-19 )
9. FOGLAMP AIMING INSPECTION (SEE PAGE 65-19 )
10. FOGLAMP AIMING ADJUSTMENT (SEE PAGE 65-19 )
Fog lamp ASSY LH
...
Adjustment
1. VEHICLE PREPARATION FOR FOGLAMP AIM ADJUSTMENT
(a) Prepare the vehicle:
Ensure there is no damage or deformation to the body around the
headlamps.
Fill the fuel tank.
Make sure that the ...
More about Toyota Highlander:
Stabilizer bar rear (FF)
REPLACEMENT
HINT:
COMPONENTS: See page 27-2 .
1. REMOVE REAR WHEEL
2. REMOVE REAR STABILIZER LINK ASSY LH
(a) Remove the 2 nuts and stabilizer link.
HINT:
If the ball joint turns together with the nut, use a hexagon
wrench (5 mm) to hold the stud.
3. REMOVE REAR STABILIZER LINK ASSY RH
...
