Toyota Highlander manuals

Toyota Highlander Service Manual: On-vehicle inspection

1. CHECK POWER SEAT FUNCTION

CHECK POWER SEAT FUNCTION


(a) Check the basic functions.

  1.  Operate the power seat switches and check to make sure each seat function works:

2. CHECK POWER SEAT MOTOR ASSY (SLIDING, FRONT VERTICAL, REAR VERTICAL AND RECLINING FUNCTIONS)

HINT: The front vertical function and rear vertical function are only available for the driver's seat.

(a) Check the PTC operation inside the power seat motor.

HINT: The PTC thermistor's resistance increases when the power seat switch is held down even after the power seat has been moved to the maximum in one direction. After the resistance increases, current is shut off to prevent a short circuit.

NOTICE: Perform steps (1) to (4) for the full range of motion for each power seat function.

  1.  Choose a power seat function. Operate the power seat switch and move the seat to the maximum in one direction. Keep the seat in that position for approximately 60 seconds.
  2.  Operate the power seat switch again and continue to try to move the seat in the same direction as in step (1). Measure the amount of time elapsed before the electrical current is automatically cut. Check if electrical current has shut off by making sure the sound of the motor has stopped.

    Standard: 4 to 90 seconds

  3.  After the current has stopped, release the power seat switch and wait for approximately 60 seconds.
  4. Operate the same power seat switch and move the seat to the opposite extreme of the direction in step (1). Check that the motor operates.
  5.  Repeat steps (1) to (4) for the remaining power seat functions.

3. Driver's seat only: CHECK LUMBAR SUPPORT ADJUSTER ASSY LH

(a) Check the PTC operation inside the power seat motor.

NOTICE: The inspection should be performed with the seat installed in the vehicle.

  1.  Operate the lumbar support switch and move the lumbar support to either the foremost or rearmost position. Keep the seat in that position for approximately 60 seconds.
  2.  Operate the lumbar support switch again and continue to try to move the lumbar support in the same direction as in step (1). Measure the amount of time elapsed before the electrical current is automatically cut. Check if electrical current has shut off by making sure the sound of the motor has stopped.

    Standard: 4 to 90 seconds

  3.  After the current has stopped, release the lumbar support switch and wait for approximately 60 seconds.
  4.  Operate the lumbar support switch and move the seat to the opposite extreme of the direction in step (1). Check that the motor operates.
Location
PROBLEM SYMPTOMS TABLE Symptom Suspected Area All power seat functions do not operate POWER M-fuse Wire harness Only slide operation fu ...

Inspection
1. INSPECT FRONT POWER SEAT SWITCH LH (a) Check the resistance between the terminals when each switch is operated. Standard: Slide switch Driver's seat only: Front vertical switch D ...

More about Toyota Highlander:

Automatic transaxle ASSY (U241E/U140F)
REPLACEMENT 1. REMOVE ENGINE ASSY W/ TRANSAXLE (SEE PAGE 14-24 ) 2. REMOVE FRONT DRIVE SHAFT ASSY RH (SEE PAGE 30-21 ) 3. REMOVE FRONT DRIVE SHAFT ASSY LH (SEE PAGE 30-21 ) 4. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING BRACKET (4WD DRIVE TYPE) (SEE PAGE 31-9 ) 5. REMOVE TRANSFER ASSY (4WD DRIVE ...

В© 2011-2024 Copyright www.tohighlander.com