Toyota Highlander manuals

Toyota Highlander Service Manual: Oil filter sub-ASSY (2AZ-FE)

Toyota Highlander Service Manual / Lubrication / Oil filter sub-ASSY (2AZ-FE)

REPLACEMENT

CAUTION:

1. DRAIN ENGINE OIL

(a) Remove the oil filler cap.

(b) Remove the oil drain plug and drain the oil into a container.

2. REMOVE OIL FILTER SUB-ASSY

REMOVE OIL FILTER SUB-ASSY


(a) Using SST, remove the oil filter.

SST 09228-06501

3. INSTALL OIL FILTER SUB-ASSY

(a) Check and clean the oil filter installation surface.

(b) Apply clean engine oil to the gasket of a new oil filter.

INSTALL OIL FILTER SUB-ASSY


(c) Lightly screw the oil filter into place by hand,Tighten it until the gasket contacts the seat.

(d) Using SST, tighten the oil filter.

SST 09228-06501

  1.  Depending on the work space available, choose from the following.

Torque: 17.5 NVm (178 kgfVcm, 13 ftVlbf)

4. ADD ENGINE OIL

(a) Clean and install the oil drain plug with a new gasket.

Torque: 25 NVm (255 kgfVcm, 18 ftVlbf) (b) Fill with fresh engine oil.

Specification:

ADD ENGINE OIL


(c) Install the oil filler cap.

5. CHECK FOR ENGINE OIL LEAKS

Lubrication system (2AZ-FE)
On-vehicle inspection 1. CHECK ENGINE OIL LEVEL (a) Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark. I ...

Oil pump ASSY (2AZ-FE)
...

More about Toyota Highlander:

Air bag sensor rear LH
COMPONENTS REPLACEMENT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. Installation is in the reverse order of removal. 1. PRECAUTION (SEE PAGE 60-1 ) 2. DISCONNECT BATTERY NEGATIVE TERMINAL (SEE PAGE 60-1 ) 3. REMOVE TONNE ...

В© 2011-2024 Copyright www.tohighlander.com