COMPONENTS
REPLACEMENT
NOTICE: Check if an old gasket remains on the pipe. If remains, remove it. Check if any bolts or nuts are rusted.
If rusted, replace them.
1. REMOVE EXHAUST PIPE ASSY TAIL
(a) Remove the 2 bolts and pipe tail from the exhaust pipe center.
(b) Remove the pipe tail from the exhaust pipe support.
2. REMOVE HEATED OXYGEN SENSOR
(a) Disconnect the heated oxygen sensor (bank 1 sensor 2) connector.
3. REMOVE EXHAUST PIPE ASSY CENTER
(a) Remove the 2 bolts and pipe center from the exhaust pipe front.
(b) Remove the pipe center from the 4 exhaust pipe supports.
4. REMOVE EXHAUST PIPE ASSY FRONT
(a) Remove the 2 bolts and pipe front from the exhaust manifold.
5. INSTALL EXHAUST PIPE ASSY FRONT
(a) Install a new gasket and the pipe front to the exhaust manifold with the 2 bolts.
Torque: 48 NVm (489 kgfVcm, 35 ftVlbf)
6. INSTALL EXHAUST PIPE ASSY CENTER
(a) Install the pipe center to the 4 exhaust pipe supports.
(b) Install a new gasket and the pipe center to the pipe front with the 2 bolts.
Torque: 56 NVm (571 kgfVcm, 41 ftVlbf)
7. INSTALL HEATED OXYGEN SENSOR
(a) Install the heated oxygen sensor (bank 1 sensor 2) to the pipe front.
Torque: 44 NVm (449 kgfVcm, 32 ftVlbf)
HINT:
After installing the sensor, check that the sensor wire is not twisted. If it is twisted, remov
8. INSTALL EXHAUST PIPE ASSY TAIL
(a) Install the pipe tail to the exhaust pipe support.
(b) Install a new gasket and the pipe tail to the pipe center with the 2 bolts.
Torque: 48 NVm (489 kgfVcm, 35 ftVlbf) (c) Install the pipe to the 3 exhaust pipe supports.
9. CHECK FOR EXHAUST GAS LEAKS
If gas is leaking, tighten the areas necessary to stop the leak.
If damaged, replace it.
Engine oil
With the engine at operating temperature and turned off, check the oil
level on the dipstick.
Checking the engine oil
Park the vehicle on level ground. After warming up the engine
and turning it off, wait more than 5 minutes for the oil to drain
back into the bottom of the engine.
Holdin ...