REPLACEMENT
1. REMOVE FRONT WHEEL RH
2. REMOVE ENGINE UNDER COVER NO.1
3. REMOVE FRONT FENDER APRON SEAL RH
4. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Loosen bolts A and B.
(b) Loosen adjusting bolt C and remove the belt.
5. REMOVE VANE PUMP V BELT
(a) Loosen bolts A and B, and remove the belt.
6. INSTALL VANE PUMP V BELT
(a) Install the belt on each pulley.
(b) Using a bar, adjust the belt tension and tighten bolt B.
Torque: 43 NVm (438 kgfVcm, 32 ftVlbf) (c) Tighten bolt A.
Torque: 43 NVm (438 kgfVcm, 32 ftVlbf)
7. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(a) Install the belt on each pulley.
(b) Tighten adjusting bolt C, and adjust the belt tension.
(c) First tighten bolt A, and then B.
Torque: 58 NVm (591 kgfVcm, 43 ftVlbf) for bolt A 18 NVm (184 kgfVcm, 13 ftVlbf) for bolt B
8. INSPECT DRIVE BELT TENSION (See page 14-121 )
9. INSTALL FRONT WHEEL RH
Location
PROBLEM SYMPTOMS TABLE
Symptom
Suspected Area
All power seat functions do not operate
POWER M-fuse
Wire harness
Only slide operation function does not operate
Front power seat switch
Slide motor
Wire harness
...