REPLACEMENT
HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ).
1. REMOVE ENGINE UNDER COVER NO.1
(a) Remove the 6 screws, 2 clips and under cover.
2. REMOVE FRONT FENDER APRON SEAL RH
(a) Remove the clip, 2 bolts and apron seal.
3. REMOVE CRANKSHAFT POSITION SENSOR
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
4. INSTALL CRANKSHAFT POSITION SENSOR
(a) Install the sensor with the bolt.
Torque: 8.0 NVm (82 kgfVcm, 71 in.Vlbf) (b) Connect the sensor connector.
5. INSTALL FRONT FENDER APRON SEAL RH
(a) Install the clip, 2 bolts and apron seal.
6. INSTALL ENGINE UNDER COVER NO.1
(a) Install the 6 screws, 2 clips and under cover.
The blind spot monitor function
The blind spot monitor function uses radar sensors to detect vehicles
that are traveling in an adjacent lane in the area that is not reflected in
the outside rear view mirror (the blind spot), and advises the driver of
the vehicles existence via the outside rear view mirror indicator.
The blind ...